Advanced home.
Advanced switches.
Normal wall switches offer on and off control. Normal dimmer switches offer a single, manual light setting. WallSwipe creates a Z-Wave switch by fusing together the power of the connected Nano modules, a presence sensor and touch-sensitive glass normally used in smartphones.
Slide
Sliding your finger up and down WallSwipe’s touch sensitive glass allows you to change the setting of whatever it’s connected to. Swipe up or down to control lights or curtains.
Swipe
Control your switches without even touching them; simply wave your hand in front of WallSwipe. Utilising a 6cm IR sensor, WallSwipe can operate in light or dark – so you can use your switch without even seeing it.
Tap
Go straight to the setting you need. WallSwipe’s glass surface has 11 different control touch-sensitive zones. Tap on any of them, and WallSwipe will change directly to that setting. Lights dimmed to 50%? Tap half way. Window blinds fully open? Tap at the top.
Touch
WallSwipe’s advanced features don’t all have to be used. For simpler control, WallSwipe can be be used as a simple on and off switch. Tap your lights and electronics on, and then tap them off again. Fully open or close curtains with a simple touch.
Simple to install.
Your licensed electrician will use the included connection cable to plug WallSwipe into your Nano module – in seconds. Attaching it to your wall is just as easy because it is compatible with Australian switch plate holders.
Step 1
Your electrician will install Nano Dimmer, Nano Switch or Nano Shutter to your electrical circuit so you can enjoy smart Z-Wave control of the connected lighting or motor.
Step 2
Your Nano module is then held firmly in place in the special built-in holder on the back of WallSwipe – the included connector cable is then attached to join Nano and WallSwipe together.
Step 3
Your electrician will then attach the WallSwipe and included switch face-plate to your wall switch holder. Job done… you can now enjoy intelligent switch control of your advanced smart home.
Nigel (verified owner) –
These work great, look great.. Until they don’t. I have been through 3 units, 1 of which I blamed on moisture due to the environment, but another one, has failed in the same way, 2 weeks after installation.
Ever single unit I have used seem to work great for a period of time, then start turning on and off randomly, and randomly dimming. To me, it appears that the touch surface gets noisy very quickly. Cleaning the surface does not help. If I had to guess, humidity, even normal indoor levels, gets under the glass, and starts to confuse the sensor.
Do not buy, overly expensive, and does not last. I have 2 more in a box waiting to be installed, and that is where they will stay. I will not be installing these anywhere anymore.